QUICKLY REMOVE 

WELDS AND BURRS

Do you have to remove or deburr welds or milling lines frequently? Then look no further than the Rebel One unitized M-Line, which gets the job done quickly and with a fine finish, without any loss of work comfort.

REBEL ONE UNITIZED

Naturally, we don’t go randomly adding new lines to our range of three-dimensional abrasive materials. The M-Line more than proves its usefulness, especially when welds or milling lines must be removed. Definitely when it must be done quickly and a slightly rougher finish is sufficient. This is a result of its slightly more aggressive actions, resulting in time saved and much less heat developed. However, if a decorative finish is required, then you’re better off using the S-Line.

Furthermore the M-Line is an excellent choice to remove burrs from a work piece. But that’s not all. It can also be used perfectly to clean screw threads or break off angles, and even grinds down aluminium. Lastly, the M-Line is highly suitable for structuring.

SLIGHTLY ROUGHER FINISH

You will see, the M-Line is an indispensable addition if you want to more quickly, more safely, and more comfortably finish your stainless steel and non-ferrous materials.

M-LINE IN SHORT

Removing milling lines and welds, deburring.

More aggressive than the S-line, with a slightly rougher finish.


Grain

Aluminium oxide

Density

Finish

5 - 8

Stock removal

Control over work piece

CONVINCED OF THE POWER

OF THE M-LINE?

3 → 5

Cibo nv/sa

Deugenietstraat 5

3150 Tildonk

Tel. 016 61 85 85

Fax 016 61 84 84

info@cibo.be

www.cibo.be